Wireless Networking

Intro

Wireless networking is used to wirelessly communicate devices to a network. Data is transmitted using radio waves. The Wi-Fi Alliance establish international standards to allow interoperability and backwards compatibility. The original standards 802.11b was only capable of transferring data at 11 Mbps and the current 802.11ac standard can achieve 500Mbps.

Devices

These are connected by using a WAP (Wireless Access Point), this is a bridge between a wireless network and a wired network. They broadcast a wireless signal which other devices can connect to, all the devices share the bandwidth of the access point. The Access Point is normally connected to a single wired network port. In the home this could be packaged with a router and a network switch, but can also be a stand alone device.

A receiving device called a Wireless Network Interface Card. These can be added to a mobile device or a computer by using either a Wi-Fi dongle or a Wi-Fi PCIe Card. It is the device used to connect to a wireless network, receive and transmit data wirelessly.

Standards / Technologies

These are a few different types of network technologies. The most common and newest version is 802.11ac but there are different types including 802.11a/b/g/n/ac/ac/ab. Speeds have increased from approximately 11mbps to 500mbps.

Distance

Distance affects the signal of the Wi-Fi, if the signal is indoors it can spread to a distance of 50-70m and outdoors it can spread to a distance of 250m. It is weaker indoors because of interference like doors, walls, pipework and microwaves.

SSID

Each network is set a SSID (Service Set Identification). This is the name that is associated with a network. When a device is trying to connect to a network, the device will search for a network . and that network will report back with its SSID. Some networks don't broadcast there SSID. This is so that people cant connect to the network so that the network is more secure.

MAC Address

A MAC (Media Access Control) address is a group of hexadecimal digits that contain information about that device that broadcasts data. the first three groups represents the manufacturer (or manufacturer & type of device) and the last three groups represent your actual device.

CSMA/CA

Ethernet uses the CSMA/CD protocol which detects if a data collision has occurred, it will stop the transmission on the colliding devices and each will wait a random amount of time before resending.

CSMA/CA actually checks the communication channel is idle before sending any data. This will prevent collisions.

CSMA/CA with RTS/CTS

RTS/CTS adds an extra layer onto CSMA/CA, by checking if the receiving machine is ready to receive data. A Request To Send is transmitted, and when ready the receiver will transmit a Clear To Send.

Stations

A station has a radio frequency and a channel that it is broadcasted at. The old Wi-Fi frequency is 2.4Ghz which is what all Wi-Fi capable devices can use but there is a new frequency that is 5Ghz. The main benefit of this is that not many devices use this new technology so that means that there wont be as much interference hence better speeds. Also the frequency is broken up into approximately 12 channels that are used.

Wireless Network Security

There are many different ways that you can secure a network.

• Change the default SSID to your own
• Hide the SSID
• Create a whitelist to only allow certain devices to connect to the network
• Secure the network with a password using WPA/WPA2

WPA/WPA2

WPA or Wi-Fi Protected Access is a protocol that secures a Wi-Fi network. It was developed by the Wi-Fi Alliance to secure wireless networks. WPA was rolled out in 2003 and then WPA2 was introduced in 2004 improving upon WPA.

It replaced WEP which used a single key for all data packets, however WPA/WPA2 use a different key for each packet.